A new medical device developed by Rice University students will help premature babies in developing countries receive life-saving oxygen without damaging their eyesight.
The World Health Organization estimates that up to 95% of the 2.4 million premature babies born each year require respiratory support. The best method of treatment is a traditional CPAP with an air-oxygen blender system, which is critical for maintaining appropriate levels of oxygen.
Unfortunately, these devices can cost thousands of dollars; therefore, medical providers in low-resource countries are often forced to improvise treatment. Unfortunately, this can lead to complications including lung damage and/or retinopathy of prematurity , which is caused when premature babies get too much oxygen. Severe cases of this condition can lead to blindness.
"Avatar The Last Air Blender," a Rice 360 team doing work at the Oshman Engineering Design Kitchen (OEDK), is made up of Harlan Cook, Ojas Dumbre, Brennan Keogh and Leora Maksoud. They set out to develop a simple, inexpensive air blender to address this health issue. It was also critical for the team to design something that could work without power - since electricity is not always readily available or reliable in low-resource settings.
As the team developed their device they based their 3-D printed design off a syringe. A plunger fitting into the syringe tube was attached to a narrow cylinder that allows a thin stream of oxygen to flow through. Thanks to the Venturi effect, the oxygen content diffuses as it travels through the cylinder, and the plunger can be adjusted to vary the ratio of air and oxygen coming in, "blending" the air. The end product is a low-cost device that delivers a safe level of oxygen to premature babies.
While the team is still fine-tuning their device, they hope it will eventually be available for mass production and distribution to areas in need.
