Fastest Soft Robot Yet Works Without Electronics

University of California - San Diego

Video: https://youtu.be/Mp2bKRevnC4?si=Tppd99zkCukwFCmV

The fastest robot to be made entirely of soft materials can reach speeds of up to 4.72 meters – a little more than 5 yards – per second, engineers at the University of California San Diego have shown. The six-legged robot can run on a wide range of terrain, from sand, to mulch, to concrete. It can also swim in water and walk underwater. The robot, designed, built and tested at the UC San Diego Jacobs School of Engineering, is 3D-printed in one go using only one material and doesn't need electronics to function.

Researchers detail their work in the Nov. 18 issue of Science Robotics.

The research team built on its first 3D-printed, air-powered soft robot, developed in 2022 and detailed in a 2025 article in Science Robotics. That robot could go just 4 centimeters – about 1.5 inches – per second and its speed was limited by the air pressure and airflow it could handle. The team, led by postdoctoral researcher Yichen Zhai and Professor Michael T. Tolley, in the Bioinspired Robotics and Design Laboratory at the UC San Diego Jacobs School of Engineering, set out to exceed this speed limit – and blew right past it.

The inside of the electronics-free robot consists of a connected series of chambers, valves, and tubes that drive the movement of the legs once pressurized air passes through. The best way to increase speed is to increase the pressure that passes through these structures. So researchers had to make the robot, and the structures inside it, bigger and stronger to accommodate higher pressures and faster airflow. But, these higher pressures can make the robot move so quickly that it becomes very inefficient, exhausting high pressure air that still contains a lot of energy.

To make their robot run more efficiently, the team turned to the design of the compound steam engine, which allows steam to expand through multiple chambers, to make the most of the energy in the high pressure air. Researchers built a series of chambers and valves into the robot to allow pressurized air to circulate twice–first in smaller, high-pressure chambers to power the valves, and then in larger, low-pressure chambers to move the legs. The end result was allowing the robot to run more than 100 times faster than the original version developed in 2022.

"Our first walking robot demonstrated what was possible, but it was too slow. We hoped to overcome this limitation, and we were fortunate to find a solution to make the new robot 100 times faster," said Zhai, who is a former postdoctoral researcher in Tolley's lab.

The team tested the robot on a wide range of surfaces, including concrete, gravel, lawn, mulch and even sand. They showed the robot could run down stairs, swim in water, and still function underwater.

"The key challenge was to implement a time-tested solution (the compound steam engine) in a soft running robot that can be printed in a single piece out of a single material. We see this as a step towards complex and powerful robots that can be printed on the desktop using inexpensive materials"

For now, the robot can only function when tethered to a source of compressed air, such as a traditional air compressor. In the future, researchers plan to explore designs that use less compressed air, so that the robot can operate untethered with a portable air source, such as a cartridge of compressed air. They also envision designs capable of more complex motions allowing steering and object manipulation.

This class of 3D-printed, electronics-free robots could eventually be used in settings where electronics cannot function, including scientific reconnaissance in areas with high radiation or magnetic fields, disaster response and space exploration.

The work was funded by the National Science Foundation.

Printing Powerful Soft Robotics on a Desktop

Yichen Zhai and Michael T. Tolley, Department of Mechanical and Aerospace Engineering, UC San Diego

/Public Release. This material from the originating organization/author(s) might be of the point-in-time nature, and edited for clarity, style and length. Mirage.News does not take institutional positions or sides, and all views, positions, and conclusions expressed herein are solely those of the author(s).View in full here.